商品詳細
ELS000001-00920196 商品名：Cisco スイッチ【WS-C2960X-24TD-L】 ★初期化済み★ ◆商品状態 初期化作業を行いました。 ※こちらの商品は詳細な動作確認を行っておりませんので、ノークレーム・ノーリターン・ノーサポートでお願いします。 ◆商品外観 品の為、キズ等があります。 ◆付属品 ・電源ケーブル ◆コンソール出力 cisco WS-C2960X-24TD-L (APM86XXX) processor (revision H0) with 524288K bytes of memory. Processor board ID FCW Last reset from power-on 1 Virtual Ethernet interface 1 FastEthernet interface 26 Gigabit Ethernet interfaces 2 Ten Gigabit Ethernet interfaces The password-recovery mechanism is enabled. 512K bytes of flash-simulated non-volatile configuration memory. Base ethernet MAC Address : BC:C4:93:E5:AD:80 Motherboard assembly number : 73-15968-02 Power supply part number : 341-0529-02 Motherboard serial number : FOC Power supply serial number : LIT19100DUJ Model revision number : H0 Motherboard revision number : B0 Model number : WS-C2960X-24TD-L Daughterboard assembly number : 73-14200-03 Daughterboard serial number : FOC System serial number : FCW Top Assembly Part Number : 800-41465-01 Top Assembly Revision Number : C0 Version ID : V03 CLEI Code Number : CMML610ARB Daughterboard revision number : A0 Hardware Board Revision Number : 0x12 Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 2 28 WS-C2960X-24TD-L 15.0(2a)EX5 C2960X-UNIVERSALK9-M Press RETURN to get started! *Mar 1 00:00:24.064: Read env variable - LICENSE_BOOT_LEVEL = Mar 30 01:27:38.150: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name = c2960x_lanbase Next reboot level = lanbase and License = lanbase May 27 04:47:55.933: Flexstack module is 1 May 27 04:48:54.223: %STACKMGR-4-SWITCH_ADDED: Switch 2 has been ADDED to the stack May 27 04:48:55.394: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down May 27 04:48:56.055: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to down May 27 04:48:57.669: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan May 27 04:49:19.738: %STACKMGR-5-SWITCH_READY: Switch 2 is READY May 27 04:49:19.738: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 2 has changed to state DOWN May 27 04:49:19.742: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 2 has changed to state DOWN May 27 04:49:20.043: %STACKMGR-5-MASTER_READY: Master Switch 2 is READY May 27 04:49:20.046: %SYS-5-RESTART: System restarted -- Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2a)EX5, RELEASE SOFTWARE (fc3) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2015 by Cisco Systems, Inc. Compiled Mon 16-Feb-15 08:16 by prod_rel_team May 27 04:49:20.231: %PLATFORM-6-FLEXSTACK_INSERTED: FlexStack module inserted in Switch 2. May 27 04:49:22.038: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to down May 27 04:49:22.126: %USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45. --- System Configuration Dialog --- Enable secret warning ---------------------------------- In order to access the device manager, an enable secret is required If you enter the initial configuration dialog, you will be prompted for the enable secret If you choose not to enter the intial configuration dialog, or if you exit setup without setting the enable secret, please set an enable secret using the following CLI in configuration mode- enable secret 0 ---------------------------------- Would you like to enter the initial configuration dialog? [yes/no]: n Switch>en Switch#sh startup-config startup-config is not present Switch#sh vlan ◆